Scsi Setup Utility; Starting And Exiting The Scsi Setup Utility - Fujitsu PRIMERGY RX200 S2 User Manual

8.3 SCSI Setup Utility

This section explains settings for the SCSI Setup Utility and items regarding each
setting. When an array is configured with the onboard SCSI array controller, settings
in the SCSI Setup Utility must be made.

8.3.1 Starting and Exiting the SCSI Setup Utility

The following explains how to start and exit the SCSI Setup Utility.
■ How to Start the SCSI Setup Utility
1
During server startup (POST), press the [Ctrl] + [C] keys while the message
"Press Ctrl-C to Start LSI Logic Configuration Utility..." is displayed on the
screen.
The [Main] menu appears.
LSI Logic MPT SCSI Setup Utility
<Boot Adapter List> <Global Properties>
LSI Logic Host Bus Adapters
Adapter
<1020/1030
Esc=Abort/Exit
F2=Menu
2
Select the menu or adapter to be configured.
• Pressing the [Esc] key moves the cursor from the header to the adapter list area.
Use the [←] and [→] keys to select between [Boot Adapter List] and [Global Properties].
• Pressing the [F2] key moves the cursor from the list area to the header. When you move the
cursor for the first time, press the [F2] key twice.
Use the [↑] and [↓] keys to select the adapter to be configured.
3
Press the [Enter] key.
The selected menu appears.
4
Configure menus and adapters.
Version
PCI Dev/ Port IRQ NVM
Bus Func Number
3 28> 3000 10 Yes
ArrowKeys=Select Item
Home/End=Select Item
PRIMERGY RX200 S2 User's Guide
MPTBIOS-IMx.xx.xx
Boot LSI Logic RAID
Order Control Status
0 Enabled --
-/+=Change[Item]
Enter=Execute<Item>
Header
List area
8
233