Table of Contents
Advertisement
EN9110
INSTALLATION INSTRUCTIONS (cont)
Preparing To Install The Optional Wall Mount Arm (Not Included)
CONNECTIONS
This monitor can be attached to a wall mounting arm you can purchase
separately from Ergotron (www.ergotron.com). Turn the power OFF then dis-
connect the cables from the monitor before performing the procedure below.
Lay the monitor face down on a soft surface.
1. Remove wall mounting hole cover.
2. Remove the cable cover.
3. Remove the 4 screws holding the base to the back of the monitor.
4. Remove the base.
8
Advertisement
Table of Contents
