Feature 'C' Programming - Autopage C3-RS-665 Installation Manual

FEATURE "C" PROGRAMMING:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 7 times (holding in on the 7th push) until three
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'C' programming mode.
Press and release the transmitter button corresponding to the feature you
want to program.
One Chirp /
Press
LED one pulse
Transmitter
Factory Default
Button
Setting
Gasoline Engine
1 +
Factory alarm
disarm with
2
channel 2 on
H7/12 Pink Wire =
3 +
Two step door
unlock output
Constant parking
light output upon
4
Remote Start
20 minutes run time
5
Door lock before
6
start
Press
7 + Activate Remote
Start.
AUTOMA TIC
8 +
TRANSMISSION
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
NOTE: Before an attempt to remote start, the unit must be programmed for a system
type, Tachometer Check, Voltage Check or Timer Check.
If none of the check types have been programmed, The Remote start will have not
functioned properly.
Two Chirps /
LED two pulse
Diesel Engine
without
Wait-To-Start Light
10 seconds
warm-up timer
Without this feature
H7/12 Pink Wire =
Factory Security
Disarm Signal
Output
Flashing parking
light output upon
Remote Start
30 minutes run
time
Door lock after
shut-down
Press
button =
button =
Activate Remote
Start.
Three Chirps /
LED three pulse
Diesel Engine
without
Wait-To-Start
Light
15 seconds
warm-up timer
H7/12 Pink Wire =
Start Status
Output
(Shock Sensor
Bypass)
10 minutes run
time
Door lock before
start and Door
lock after
shut-down
-
22
Four Chirps /
LED four pulse
Diesel Engine
without
Wait-To-Start
Light
20 seconds
warm-up timer
H7/12 Pink
Wire = Start
Status Output
(Shock Sensor
Bypass 20
SEC)
5 minutes run
time
Without this
feature