Chapter 4: Troubleshooting; Using Lanview; About The Management (Mgmt) Led; Troubleshooting Checklist - Enterasys 6H308-48 Hardware Installation Manual

Dfe‐gold series module

Hide thumbs Also See for Enterasys 6H308-48:

Table of Contents

This chapter provides information concerning the following:

For information about...

Overview of DFE Module Shutdown Procedure

Recommended Shutdown Procedure Using OFFLINE/RESET Switch

Last Resort Shutdown Procedure Using OFFLINE/RESET Switch

Using LANVIEW

The DFE module uses a built‐in visual diagnostic and status monitoring system called

LANVIEW. The LANVIEW LEDs (Figure

status to aid in diagnosing network problems.

The MGMT LED (shown in Figure

Management Module to control the management functions for all DFE‐Gold modules in

the chassis. The Management Module handles all IP requests to the chassis IP address,

such as PING, Telnet, SNMP, HTTP, and more. The Management Module also handles the

CLI configuration sessions through the console port. So, when you plug into a

DFE‐Gold module COM port to configure a DFE‐Gold module in the chassis, it is handled

by the Management Module regardless of the DFE‐Gold module COM port that you use.

4‐1) allow quick observation of the network

4‐1) indicates when the module is serving as the

Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 4-1

Troubleshooting

Refer to page...

4-1

4-7

4-9

4-10

Table of Contents

Troubleshooting