Reinstalling the Safety Cover
To install the safety cover, refer to Figure
Warning: The safety cover protects you from exposure to an energy hazard in excess of
240 Volt-Amperes. Never operate the DFE module without the safety cover installed.
Advertencia: La cubierta de seguridad lo protege de exponerlo al riesgo de energía en
exceso de 240 Volt-Amperes. Nunca se debe opererar el modulo de DFE sin la cobertura
de seguridad instalada.
Warnhinweis: Die Sicherheitsabdeckung schützt vor Stromstössen von bis zu 240 VA.
Bitte nehmen Sie niemals die DFE Module ohne die Abdeckung in Betrieb.
1.
Locate the seven screws saved in the procedure "Removing the Safety Cover" on
page B‐5.
2.
Fasten the safety cover to the standoffs using the seven screws. This completes the
safety cover installation.
B‐10 and proceed as follows:
Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-13
Gaining Access to Memory Modules