Slip Linxslp - Motorola MOSCAD 68P02958C00-B User Manual

SLIP LINxSlp
## 2300 LEVEL = 0
Slip port parameters
---------------------
formater key
port mode
port rate
port from
port flow control
Is device down
Is char being received
Is driver wait during transmission: %%8
Char that is being received
Has device went up ?
Is driver being stopped ?
Is reception from port being held? : %% 12
Is driver PPP ?
Maximal no reception time to declare disconnect [sec]: %%14
Time elapsed since last Slip/PPP reception [sec]
Is driver being stopped
Is driver being started/connected
Last error when started driver (HEX)
Is disconnected driver on ?
Was AT response been received when driver was up ?
Send optional String
Is driver being freezed ?
1. Not relevant.
2. Not relevant.
3. Baud rate of port, as defined in Site Configuration.
4. Not relevant.
5. Type of flow control (DTR/CTS) as defined in Site Configuration.
6. Not relevant.
7. Not relevant.
8. Not relevant.
9. Not relevant.
10. Has the SLIP device been activated?
11. Is transmission of IP datagrams through SLIP device currently paused?
12. Is reception of IP datagrams through SLIP device currently paused?
Note: 11 and 12 are YES when initializing modem (e.g. iDEN) using AT commands.
13. YES if driver is PPP; NO if it is SLIP.
: %%1
: %%2
: %%3
: %%4
: %%5
: %%6
: %%7
: %%9
: %% 10
: %% 11
C-93
Software Diagnostics Output
: %%13
: %%15
: %%16
: %%17
: %%18
: %%19
: %%20
: %%21
: %%22