Moscad Nfm Overview - Motorola MOSCAD 68P02958C00-B User Manual

Send commands to the MOSCAD RTU and download parameters to its local process.
Send commands via broadcasts to any required group of RTUs.
Download parameters (set-points) to the RTU local process.
Receive spontaneous reports (by contention) from RTUs (both burst and event
transmission).
Receive time-tagged events logged in the RTUs (1 msec resolution).
Adjust the RTU clocks (1 sec resolution).
Synchronize the RTU clocks (1 msec resolution), using an external CPU with GPS.
Support redundant IP Gateway configuration.
Set the Gateway mode (Primary/Secondary).
Retrieve Gateway status.
Retrieve RTU links status.

MOSCAD NFM Overview

The MOSCAD NFM system provides communication providers with a solution for
supervising and controlling the operation of conventional and trunked radio, analog and digital
cellular, microwave radio and wireline telecommunication systems.
The MOSCAD NFM system provides the Network Management Center (NMC) with access to
the communication and environmental devices and gives the operator and the system manager
the tools needed to identify and fix faults within the communication system.
Figure 1-3 describes the general architecture of the MOSCAD NFM, which includes control
center workstations and computers that exchange data with the IP Gateway, allowing the NMC
to monitor and control non-SNMP devices at the communication sites.
1-4
Introduction