Motorola MOSCAD 68P02958C00-B User Manual page 303

4. The number of times the MDLC frame was retried without receiving ACK.
5. The number of MDLC frame retries that received Busy ACK. (The receiving site does not have
enough room to handle it because of overload).
6. The number of seconds between transmission attempts in case of Busy ACK.
7. The number of times the broadcast frame was retried.
8. The number of different addresses the Link will transmit to simultaneously.
9. The RTU Site ID.
10. The RTU System address.
11. The time that the Link layer waits when the Physical layer returns Busy to the transmission attempts
of the Link layer in "private conversation", until it retries.
12. The number of times the Link layer will try to transmit to the Physical layer, if the latter returns Busy
in "private conversation".
13. The Link layer is capable of answering a range of addresses. This number is the upper bound that the
RTU reacts to, whereas the lower bound is the Site ID.
14. Flag which indicates AUTH TX state (1=YES, 0=NO)
15. Flag which indicates AUTH RX state (1=YES, 0=NO)
16. Flag which indicates Stop obeying AUTH TX (1=YES, 0=NO)
17. Flag which indicates Start obeying AUTH TX (1=YES, 0=NO)
18. Flag which indicates Stop obeying AUTH RX (1=YES, 0=NO)
19. Flag which indicates Start obeying AUTH RX (1=YES, 0=NO)
20. Flag which indicates that AUTH is active for TX (1=YES, 0=NO)
21. Flag which indicates that AUTH is active for RX (1=YES, 0=NO)
22. Flag which indicates Obeying AUTH TX (1=YES, 0=NO)
23. Flag which indicates Obeying AUTH RX (1=YES, 0=NO)
24. TimeAuth identifier
25. TimeAuth device key (HEX)
C-11
Software Diagnostics Output