Figure 1.6 Rear Panels (Rx8200, Rx8310, Rx8315, Rx8320 And Rx8330); Rf In Connector (Rx8200 And Rx8320 Only) - Ericsson RX8000 Series Reference Manual

Chapter 2
All signal connections are made via the rear panel. A typical rear panel is shown in
Figure 2.5. Full technical specifications for the connections are given in Annex B.
The Receiver provides a flexible Transport Stream input interface. The status
information appropriate to each input type is available to the User via the User
Interface, and also via the remote control interfaces.
INPUT MODULE
RX8200
Sample configuration
with: Satellite input,
frame sync, HD video
output, IP Transport
Stream output and 2x
Audio output modules
installed.
RX8310
RX8315
RX8320
RX8330
Figure 2.5 Rear Panels (RX8200, RX8310, RX8315, RX8320 and RX8330)
2.7.2

RF IN Connector (RX8200 and RX8320 only)

Up to four RF inputs connect the L-band output of a
suitable Low-Noise Block down-converter (LNB) to the
unit either directly or via a suitable attenuator.
The RF inputs may also be used to supply DC power to
the LNB, if required.
2-10
RF IN 1-4
IP OUT 1-2 CVBS COMPONENT
VIDEO
RF IN 1-4
ASI OUT 1-2 CVBS ASI INPUT
AUDIO OUT (1) AUDIO OUT (2)
1-2 3-4
ASI/HD-SDI/SD-
SDI OUT 1-3
IP OUT 1-2
ETHERNET 1-2
FRAME ALARM
SYNC
CONTROL
ASI INPUT
1-2
AUDIO OUT (1)
1-2
ALARM
RF IN 1/2/3/4
EN/LZT 790 0005 R1A
AC POWER
TECHNICAL
EARTH
AC POWER
TECHNICAL
EARTH