Power Supply - Ac Mains Input; Cable Types - Ericsson RX8000 Series Reference Manual

Annex B
B.7 Power Supply – AC Mains Input
This equipment is fitted with a wide-ranging power supply. It is suitable for supply
voltages of 100-240 V AC -10% +6% at 50/60 Hz nominal.
Table B.25 AC Power Supply Specification
Item
Power distribution system
Connection to supply
Class of equipment
Rated voltage
Rated frequency
Voltage selection
Rated current
Input connector
Fuse
Fuse type
Fuse current rating
Power consumption
B.8

Cable Types

The signal cable types (or similar) in Table B.26 are those recommended by
Ericsson in order to maintain product EMC compliance.
B-20
Specification
Type TN ONLY (EN 60950-1 Annex V): Power distribution
system which is directly earthed, the parts of the equipment
required to be earthed being connected by protective
earthing conductors. This equipment must NOT be used
with single-phase three-wire and PE, TT or IT Type Power
distribution systems.
Pluggable Equipment Type A (EN 60950-1 para 1.2.5):
Equipment which is intended for connection to the building
power supply wiring via a non-industrial plug and
socket-outlet or a non-industrial appliance Coupler or both.
Correct mains polarity must always be observed. Do not
use reversible plugs with this equipment.
Class I Equipment (EN 60950-1 para 1.2.4): electric shock
protection by basic insulation and protective earth.
100-240 V AC (single phase)
50/60 Hz
Wide-ranging
RX83xx: 1 A (100-240 V AC range)
RX82xx: 1.5 A (100-240 V AC range)
CEE 22/IEC 3-pin male receptacle
Fuse in live conductor in power input filter at rear of unit. Do
not use reversible plugs with this equipment.
Bussmann S505
Littelfuse 215
5x20 mm time delay (T) 1500 A breaking capacity (HBC)
IEC/EN 60127-2 Sheet 5
All RX8000 models: 2 A 250 V T HBC
45 W typical (NO options fitted)
60 W maximum
EN/LZT 790 0005 R1A