Introduction; Installation Assistance; For The Home Or Businessowner; For The Installing Dealer/Contractor - Briggs & Stratton 190839GS Owner's Manual

10000 watts automatic transfer home generator system
Hide thumbs Also See for 190839GS:
Table of Contents

Advertisement

Available languages

Available languages

Briggs & Stratton Power Products
Home Generator
System
Owners
Manual
INTRODUCTION
Congratulations
on your purchase of a Briggs & Stratton
Home Generator
System (HGS).Your
HGS was designed to
provide automatic auxiliary electrical
power for the
duration of normal power interruption.
It is not intended
for use as primary power in place of utility nor for use in
life-support
applicatioes.The
generator
unit has been
engineered and tested to exacting standards of
performance and reliability and is equipped with a UL®
listed Automatic
Power Transfer Switch.
Briggs and Strat_onhas made every effort to providefor a
safe, streamlinedand cost-effective installation. B ecause
each installation is unique, it is impossible to know of and
advise the trade of all conceivableprocedures and methods
by which installationmight be achieved.Neither could we
know of possible hazards and/or the results of each
method or procedure. For these reasons,
Only
current
qualified
electrical
and
plumbing
contractors
should
attempt
HGS
installations.
Installations
must
strictly
comply
with
all applicable
codes, industry
standards
and regulations.
Your Briggs&Stratton Home Generator System issupplied
with this "Owners Manual",a separate "Installation Manual"
(part number 190838) and aWarranty Sheet (part number
190881).These are important documentsand shouldbe
retained by the owner after the installation has been
completed.
Installation
Assistance
For the Home or Business Owner:
To helpyou make informedchoicesand communicate
effectively with your installationcontractor(s),
Read and understand
the
Owner
Orientation
Section
of this manual
BEFORE
contracting
or starting
your HGS installation.
To arrange for proper installation, contact the store at
which you purchased your Briggs &Stratton
Home
Generator
System, your dealer, or your utility power
provider.
The
HGS Warranty
is VOID
unless the system
is installed
by certified
electrical
and
plumbing
professionals.
For the Installing
Dealer/Contractor:
For most applications, the Installation manual contains all
the information required to properly install and start the
Home Generator System.This Owner's Manual describes
essential circuit selection, routine operation and owner
maintenance procedures.
If you need more information, call 1-800-743-4115,
between 8:00 AM and 5_0 PM CT
The Emission Control System for this generator is
warranted for standards set by the U.S. Environmental
Protection
Agency and by the California Air Resources
Board (CARB).
OWNER
ORIENTATION
This section provides Home Generator
System owners
with the information necessary to achieve the most
satisfactory
and cost effective installation
possible.
The illustrations are for typical circumstances and are
meant to familiarize you with the installation options
available with your Home Generator System.A thorough
understanding of these options will provide fundamental
control
over the cost of your installation, es well as ensure
your final satisfaction and security.
Local codes, appearance, noise levels, fuel types, and
distances are the factors that must be considered when
negotiating with an installation professiona!. Remember that
as the distance from the existing electrical service and
gaseous fuel supply increases, equal compensations in piping
and wiring materials must be allowed for.This is necessary
to comply with local codes and overcome electrical voltage
drops and gaseous fuel pressure drops.
The factors
mentioned
above will have a direct
affect
on the overall
price of your Home
Generator
System
installation.
W
5

Advertisement

Chapters

Table of Contents
loading

Table of Contents