Removing A Standard-Form-Factor Expansion Card - IBM 8853L6U Service Manual

Removing a standard-form-factor expansion card

To remove a standard-form-factor expansion card, complete the following steps.
Standard-form-factor
expansion card
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. If a Memory and I/O Expansion Blade is installed and you are removing the
5. Gently pivot the wide end of the card out of the expansion card connectors;
6. If you are instructed to return the expansion card, follow all packaging
38
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
Expansion
card
bracket
Hard disk
drive tray
on page 19.
the blade server from a BladeCenter unit" on page 21).
page 24 for instructions).
expansion card from the system board, remove the Memory and I/O Expansion
Blade (see "Removing an expansion unit" on page 26).
then, slide the notched end of the card out of the raised hook on the expansion
card bracket and lift the card out of the blade server.
instructions, and use any packaging materials for shipping that are supplied to
you.