Removing A Standard-Form-Factor Expansion Card - IBM BladeCenter HS20 Problem Determination And Service Manual

1. Touch the static-protective package that contains the expansion card to any
2. Orient the expansion card over the system board.
3. Slide the notch in the narrow end of the card into the raised hook on the tray;
4. Install the blade server cover (see "Installing the blade server cover" on page
5. Install the blade server into the BladeCenter unit (see "Installing the blade
6. If you are instructed to return the expansion card, follow all packaging

Removing a standard-form-factor expansion card

To remove a standard-form-factor expansion card, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Gently pivot the wide end of the card out of the expansion card connectors;
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
then, gently pivot the card into the expansion card connector.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
60).
server in a BladeCenter unit" on page 58).
instructions, and use any packaging materials for shipping that are supplied to
you.
Expansion
card
Expansion
card tray
Hard disk
drive tray
on page 55.
the blade server from a BladeCenter unit" on page 57).
page 59 for instructions).
then, slide the notched end of the card out of the raised hook on the tray and lift
the card out of the blade server.
Chapter 4. Removing and replacing blade server components
67