Removing The Power Jumper - IBM 8853L6U Service Manual

4. Install the blade server cover (see "Installing the blade server cover" on page
5. Install the blade server into the BladeCenter unit (see "Installing the blade
6. Turn on the blade server and run the Configuration/Setup Utility program. Set

Removing the power jumper

If the blade server system board is equipped with power connector J164, complete
the following steps to remove the power jumper.
Note: A power jumper is not installed when a Memory and I/O Expansion Blade is
installed.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Locate the power connector J164 on the system board.
5. Lift and remove the power jumper from the power connector.
25).
server in a BladeCenter unit" on page 22).
configuration parameters as needed (see "Using the Configuration/Setup Utility
program" on page 11 for information).
Power jumper
on page 19
the blade server from a BladeCenter unit" on page 21 for instructions).
page 24 for instructions).
Chapter 4. Removing and replacing blade server components
43