Removing A Memory Module - IBM 8853L6U Service Manual

Removing a memory module

The following illustration shows the locations of the DIMM sockets on the system
board.
The following illustration shows the locations of the DIMM sockets on the optional
IBM BladeCenter Memory and I/O Expansion Blade.
To remove a DIMM, complete the following steps.
1. Read the safety information that begins "Safety" on page vii and "Installation
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
guidelines" on page 19
the blade server from a BladeCenter unit" on page 21).
page 24).
DIMM 4 (J144)
DIMM 3 (J143)
DIMM 2 (J142)
DIMM 1 (J141)
DIMM
Retaining clip
Chapter 4. Removing and replacing blade server components
DIMM 8 (J19)
DIMM 7 (J18)
DIMM 6 (J21)
DIMM 5 (J20)
31