Removing The Bezel Assembly; Installing The Bezel Assembly - IBM 8853L6U Service Manual

Removing the bezel assembly

To remove the bezel assembly, complete the following steps.
Bezel-assembly
release (both sides)
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Open the blade server cover (see "Removing the blade server cover" on page
3. If a Memory and I/O Expansion Blade is installed, remove it (see "Removing an
4. Press the bezel-assembly release on each side of the blade server and pull the
5. Disconnect the control panel cable from the control panel connector.
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.

Installing the bezel assembly

To install the bezel assembly, complete the following steps.
Bezel-assembly
release (both sides)
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Connect the control-panel cable to the control-panel connector on the system
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
28
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
on page 19.
24 for instructions).
expansion unit" on page 26).
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
on page 19.
board.
Control-panel
cable
Bezel
Control-panel
connector
Control-panel
cable
Bezel
Control-panel
connector