Cr_Pcstore Command; Cr_Setpcadj Command - Sanyo PLC-WM5500/L - 5500 Lumens Manual

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications
9.5.9

CR_PCSTORE Command

Command "CR_PCSTORE" [CR]
Get Free or Stored status of MODE1 - 10 in PC Adjust.
Details Data consists of 10 bytes and each byte represents MODE1-10.
(F:Free, S:Stored)
Acceptable
Response
%1
Unacceptable

9.5.10 CR_SETPCADJ Command

Command "CR_SETPCADJ" [CR]
Details Get PC signal for current system
Acceptable
Response
%1
Unacceptable
"000_%1" [CR]
"FFFFFFFFFF" ---------------- ALL Free
"SFFFFFFFFF" --------------- Mode1 is Stored, others are Free
:
"FFFFFFFFFS" --------------- Mode10 is Stored, others are Free
"SSSSSSSSSS" ------------- ALL Stored
"Error Code" [CR]
"000_%1" [CR]
When input signal is PC Analog;
"VGA1" ------------------------ Indicates VGA1 is selected
"VGA2" ------------------------ Indicates VGA2 is selected
:
:
"XGA1" ------------------------ Indicates XGA1 is selected
:
:
"WXGA3" --------------------- Indicates WXGA3 is selected
"1080I" ------------------------ Indicates 1080i is selected
"1035I" ------------------------ Indicates 10350i is selected
"720P" ------------------------- Indicates 720p is selected
"575P" ------------------------- Indicates 575p is selected
"480P" ------------------------- Indicates 480p is selected
"575I" -------------------------- Indicates 575i is selected
"480I" -------------------------- Indicates 480i is selected
"1080PSF/24" ----------------- Indicates 1080psf/24 is selected
"1080PSF/25" ----------------- Indicates 1080psf/25 is selected
"1080PSF/30" ----------------- Indicates 1080psf/30 is selected
:
"MODE10" ------------------- Indicates Mode10 is selected
"EXT11" ---------------------- EXT11 is selected
:
"EXT60" ---------------------- EXT60 is selected
* Error Code "101" [CR] is returned for no signal.
* When input signal is not PC Analog, error code "101" is
returned.
"Error Code" [CR]
62/88