PLC-WM5500/WM5500L Expand Serial Command Functional Specifications
8.4.8
CF_COLTEMP Command
Command
"CF_COLTEMP_%1" [CR]
"000" ------------------------------ Xlow
"001"------------------------------- Low
%1
"002"------------------------------- Mid
"003"------------------------------- High
Set Color Temperature
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.4.9
CF_OFFSET- Command
Command
"CF_OFFSET-%1_%2" [CR]
"R" --------- RED
%1
"G" --------- GREEN
"B" --------- BLUE
"000-063"------ Directly specify value of Color selected in %1 of Offset.
%2
"UP"------------ Increment setting value of Color specified in %1 of Offset by 1
"DN"------------ Decrement setting value of Color specified in %1 of Offset by 1
Set value of Color specified in %1 of Offset (Available only in the normal Power ON
status)
Details
The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.4.10 CF_NZRED Command
Command
"CF_NZRED_%1" [CR]
"OFF" ---------------- Cancel Noise Reduction
"ON" ------------------- Set Noise Reduction
%1
"UP" ------------------ Toggle between ON and OFF. (On→OFF→On→...)
"DN" ------------------ Toggle between ON and OFF. (On→OFF→On→...)
*"UP" and "DN" are exactly same operation.
Set Noise Reduction level (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It returns to the original setting in Suspend mode as well.)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code"[CR]
"000" [CR]
"Error Code" [CR]
21/88