Bosch SHESAM Use And Care Manual page 79

To remove the top spray arm:
1. Remove the empty top rack from the dishwasher.
2. Turn the rack upside-down. The top spray arm is held in position by a locking nut as shown
in Figure 17A. Turn the locking nut counter-clockwise 118 turn and remove it, as shown in
Figure 17B to release the spray arm.
3. Remove the spray arm as shown in Figure 18.
4. Look for obstruction in the spray nozzles.
5. If the spray nozzles need cleaning, flush them under running water.
To reinstall the top spray arm:
1. Return the top spray arm to its installed position,
2. Return the locking nut to its installed position and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in Figure 19.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush them under running water.
To reinstall the bottom spray arm:
7. Return the bottom spray arm to its instalted position and press it so that it snaps into
place.
2. Return the bottom rack to its installed position.
Chec_JClean the Filter System
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter, Select models have an additional Micro Filter. The filter system is located on the
inside of your dishwasher under the lower rack and is easily accessible.
During normal use, the filter system is self-cleaning. You should occasionally inspect it for foreign
objects and dean it when necessary.
/k CAUTION
To avoid injury, do not reach into the large object trap with your fingers. The large object
trap could contain sharp objects.
To Remove the Large Object TraplCylinder Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 20 and turn it counter clockwise 1/4 turn.
3. Lift out the assembly as shown in Figure 21 and 22.
4. Carefui_yexamfne the assemb_y_ _fy_u find debdsin the Large _bject Trap_turn it upside*d_wn
and gently tap it on a surface such as a countertop to dislodge and remove the debris. Flush
the Cylinder Filter clean by holding it under running water. Place parts back in unit and lock
as shown in Figure 23.
Figure 20
TO open - turn counterclockwise.
Figure 21
Large Object Trap
Figure 22
Figure 23
To close - turn clockwise.
15