Bosch SHESAM Use And Care Manual page 138

Rinse Agent Dispenser
Open the rinse agent dispenser by lifting the tab with your thumb.
NOTE: The dishwasher indicates low rinse agent either by showing the symbol "_ in the
countdown display, or illuminating the refill rinse agent light (model dependent).
Add liquid rinse agent to the dispenser as shown in Figure 16 until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the indicator light will go out in a few minutes
after the dishwasher door is shut (select models only).
Wash Cycles (See Cycle Chart)
Always make sure your dishware isdishwasher safe.Refer to the Dishware Materials
sectionof this manual for guidance.
Power Scrub Plus
Cleans items having baked-on or hard dried-on food soils. These items may require
soaking or hand scouring.
Auto Wash (select models)
Cleans large loads with loosely attached food soils,
Regular
Thoroughly cleanslarge loads having looselyattached normal soling.
Delicate/Economy (select models)
For delicateor heirloomdishwasherand silverware or other specialitems. Alwaysmakesure
that the items are dishwashersafe. Referto the Materialssectionof this manual for further
information. Hand washing may bethe besttreatment of suchitems.
Quick Wash
For lightly soiled items with easy to remove food soils,
Rinse and Hold
Allows you to rinse the food soil off of a partial load and hold them in the dishwasher until
there is a full load.
Dishware Drying
At the end of the cyclethe dishwasher will stop and a period of condensation drying will
follow.
Wash Cycles
SHX3AM X
SHE5AM X
SHE4AM02 x
SHE4AM12 x
.__ 8
o o
a.
X
X X ×
X
X X
X
X
X
x
WARNING
You could be seriously scalded if you alow hot water to splash out of the dishwasher.
OPENTHE DOORCAREFULLYduri ng any wash or rinse cycle. Do not fully open the door
until water noises have stopped.
OPERATING THE SHX3AM
< >
o o on ...... 0
@ BOSCH _ _ _"_ °"°_ _ i
To start unit:
- Door must be open. Pressthe "ONIOFF" button to turn the unit on.
- Wash cycle LEDwill be flashing to indicate pre-select mode.
- Press_) or (_) to select desired wash cycle, Pressthe STARTbutton (Wash Cycle LEDwill stop flashing).
- Close the door to start cycle
NOTE:RinseAgent LEDwill be illuminated if unit needs rinse agent.
10