Bosch SHESAM Use And Care Manual page 75

WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during any
wash or rinse cycle. Do not fully open the door until water noises have stopped.
To cancel cycle:
- Open door just far enough to expose the controls _hen press the "START RESET"button until the Active LEDgoes out.
- Close the door and wait about 1 minute or until you hear the buzzer (if active)
- Open the door and press "ONIOFF"
Setting Options (rinse Agent amount I Extra Dry Heat I Cycle completion Signal)
- Door must be open. Turn unit on,
- Wash cycle LED will be flashing to indicate pre-select mode.
- To enter setup mode press and hold (_ then press and release "START RESET" button; then release (_.
Active button will be flashing to indicate setup mode.
- Press @ to select an option (Rinse Agent/Extra dry heat/Tone)
- Press @ to adjust the settings for the respective options. (Press Start to save)
To set Rinse Agent amount: Active + Rinse Agent LED flashing. Follow steps under setting options above
NOTE:If your glosses heve spots you need more RinseAgent. If your glosses hove streaks you need less RinseAgent_
Power Scrub Regular QuickWash RinseAid Setting
Wash
0 (least)
• 1
• 2
• • 3
• 4
• • s
• • 6 (most)
To set Extra Dry Heat: Active + Sanitized LEO flashing. Follow steps under setting options above
Power Regular Quick Extra dry
Scrub Wash Wash Heat
not activated
• activated
To set Cycle Completion Siqnah Active + Rinse Agent LED flashing. Follow steps under setting options above
Power ReguLar Tone set-
Scrub Wash ting
0
• Low
• Medium
• • High
11