Operating The She5Am; Operating The She4Amoll - Bosch SHESAM Use And Care Manual

OPERATING THE:
SHE4AM0
SHE4AM1
To start unit:
- Door must be closed. Press the ONIOFF button to turn the unit on.
- Program LEDs will be flashing to indicate "pre-select" mode.
Press ('_ or _ to select desired cycle.
V
- If desired press "Delay start" to select 31619 hour delayed start. If desired press the Half Load option (SHE4AM1 models only)
- Press start to begin cycle. Program select LED stops flashing and Active LED illuminates.
NOTE: Rinse Agent LED will be illuminated if unit needs rinse agent.
Child Lock
- After pressing ST(._ART you can activate the Child Lock feature.
- Press and hold _ until "Child Lock" LED illuminates. LED goes off once you release the button. Child lock is activated. Now
any button you press (except O(._N/OFF) will not function and the child lock LED will illuminate each time to indicate this
- To deactivate: press and hold _ until the child lock LED goes out.
_WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during
any wash or rinse cycle. Do not fully open the door until water noises have stopped.
TO cancel cycle:
NOTE: Child lock needs to be deactivated
Pressand hold the "Start Reset" button for 3 seconds.
The unit will drain any remaining water ( takes about 1 minute), active LEDgoes out and Clean LEDilluminates.
- Turn unit off.
Setting Options (Extra Dry Heat / Rinse Agent Amount)
- Door must be closed. Turn unit on.
- Wash cycle LEDwill be flashing tO indic_e pre-select mode. ,,
- To enter setup mode press and hold _,l then press and release Start Reset" button; then release _,'.
- Clean and one other LED will be flashing to indicate setup mode.
- Press (_ to select an option (Extra Dry Heat / Rinse Agent Amount)
- Press _) to adjust the setting for the respective option,
To set Extra Dry Heat: Clean & Sanitized LED flashing
PowerScrub Heat Setting
• Extra Dry ON
Extra Dry OFF
- Press_ to switch between the Heat and RinseAgent options,
- PressSTART to save
To set Rinse Aqent amount: Clean + Rinse Agent LED flashing
SHE4AMO
SHE4AM1
Power Regular Quick Rinse&
Scrub Wash Wash Hold
Power Auto Regular Quick
Scrub Wash Wash Wash
Rinse Aid
Setting
0
t
2
3
13