Assembly - Ariens ProZoom 99480600-1952S Owner's/Operator's Manual

WARNING: AVOID INJURY. Read and understand entire Safety section before proceeding.
Assembly
Connect Handles
The handles are disconnected and rotated forward during shipment
to allow proper fit in the shipping container.
1. Rotate handles up.
2. Connect the pump control arm (C) to the hand handle by
inserting the adjustment block (A) into the handle and securing
it with the hair pin (B).
3. Set the speed control bar to desired speed and lock.
A
Check Hydraulic Oil Level
Check Engine Oil Level
1. Lift thigh pad.
2. Clean area around dipstick cap (A).
3. Remove dipstick cap (A) from tube. Wipe dipstick clean.
NOTE: Do not tighten dipstick cap when checking oil level.
4. Insert dipstick in tube. Do not tighten cap.
5. Remove dipstick. Check oil level on dipstick. Oil level should
be between the ADD and FULL marks.
• If oil is level is below ADD mark, fitt to proper level.
• Ifoil level is above the FULL mark, drain to proper level.
6. Insert dipstick. Tighten cap.
Connect Battery
CAUTION: Avoid injury! Prevent Battery Explosions:
• Keep sparks, lighted matches, and open flame away
from the top of battery. Battery gas can explode.
• Never check battery charge by placing a metal
object across the posts. Use a volt-meter or
hydrometer.
• Do not charge a frozen battery; it may explode.
Warm battery to 16 degrees C (60 degrees F).
1. Connect positive (red) cable to battery positive (+) terminal.
Install red terminal cover (A).
2. Connect negative (black) cable to battery negative (-) terminal.
Install black terminal cover (B).
1. Clean area around dipstick cap (A).
2. Remove dipstick cap (A). Wipe dipstick clean.
NOTE: Do not tighten dipstick cap when checking oil level.
3. Insert dipstick in filler neck (B). Do not tighten cap.
4. Remove dipstick. Check oil level on dipstick. Oil level should
be between the ADD and FULL marks on dipstick.
• If oil is level is below ADD mark, fill to proper level.
• Ifoil level is above FULL mark, drain to proper level.
5. Insert dipstick. Tighten cap.
Check Machine Safety Systems
Perform safety system check to make sure the electronic safety
interlock circuit is functioning properly.
GB - 9