Finishing Using Post Inserter - Konica Minolta bizhub C654 User Manual

2.5 Post Inserter PI-505

Finishing using Post Inserter

0 Only the lower tray can be used as the output tray. The upper tray is not available.
1
Place paper in the lower tray of the Post Inserter, and align the lateral guide to the paper size.
% Load the original by placing it so that its top side faces the back of the machine.
% To use the corner staple or 2-staple option, load the paper face up.
% To perform Punch, load the paper face up.
% To perform Bind, load the front side of the bound paper face down.
% To perform Tri-Fold, load the outside of the tri-folded paper face down.
2
Press the Finishing key and Select punch key, and select the desired finishing.
% To configure Finishing settings, press the Finishing key to turn the LED on. To configure punch set-
tings, press the Select punch key to turn the LED on.
% Punch settings are available together with the corner staple or 2-staple option.
3
Press the Start/stop key.
% If the Start/stop key is pressed during operation, the operation will be stopped.
bizhub C754/C654
2
2-12