Konica Minolta bizhub C451 User Manual page 190

Administrator mode
Item
TCP/IP*
Network Speed
IP Address Setting Meth-
od*
IP Address
Subnet Mask
Default Gateway
IPv6
RAW Port Number
Dynamic DNS Setting
Host Name
DNS Domain Name Set-
ting
DNS Server Setting
SLP Setting
LPD Setting
Reminder
In order to apply the changes to the settings for items which are marked
with an asterisk (*), restart the machine (turn it off, then on again).
When the machine is turned off, then on again, turn the machine off with
the sub power switch before turning off the main power switch. In addi-
tion, wait at least 10 seconds to turn the machine on after turning it off;
otherwise, the machine may not operate correctly.
When using this machine under the IPv6 environment, there are the following
restrictions.
- Printing using SMB is not available (available for direct hosting service).
C451
Description
Select whether or not TCP/IP is used.
Select the operating speed.
Select whether the IP address is automatically acquired or is direct-
ly entered. If it is automatically acquired, select the check boxes to
specify the acquisition conditions.
Specify the IP address of the machine. (Format: ***.***.***.***; Range
for ***: 0 to 255)
Specify the subnet mask of the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)
Specify the default gateway for the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)
Select whether or not IPv6 is used.
If "ON" is selected, specify settings for the following.
• Auto IPv6 Setting*
• Global Address
• Prefix Length
• Gateway Address
Select the check box for the port to be used, and then type in the
port number. (Range: 1 to 65535)
Select whether or not Dynamic DNS is enabled.
If Dynamic DNS is enabled, type in the host name (up to 63 charac-
ters).
Select whether or not the DNS domain name is automatically ac-
quired. If it is not automatically acquired, type in the domain name
below (up to 253 characters).
A maximum of three DNS server addresses can be registered. (For-
mat: ***.***.***.***: Range for ***: 0 to 255)
If the machine is set to use IPv6, an IPv6 address can also be spec-
ified.
Select whether or not SLP is enabled.
Select whether or not LPD is enabled.
3
3-81