Setup; Parallel - Lexmark E250DN - Govt Laser 30PPM Special Build Mono Taa Service Manual

Setup

Use the Setup menu to configure how the printer formats the end of a line depending on the computer system
being used.
Menu item Use setting to
Demo Mode Put printer into demo mode where internal sheets print with each
press of
To deactivate, turn the printer off, and re-enter configuration group.
Set to deactivate.
Auto CR Specify whether the printer automatically performs a carriage return
After LF after a line feed control command.
Auto LF after Specify whether the printer automatically performs a line feed after a
CR carriage return control command.
Energy When setting is on, the user cannot disable Power Saver. When off,
Conserve Power Saver will be off.

Parallel

Use the Parallel menu to change printer settings on jobs sent through a parallel port.
Menu item Use setting to
NPA Mode Send print jobs to the printer and query printer status information
simultaneously.
Protocol Receive information at a much higher transmission rate if the printer
is set to Fastbytes (if the computer supports Fastbytes) or receive
information at a normal transmission rate if the printer is set to
Standard.
Parallel Determine whether the parallel port data is sampled on the leading
Mode 2 (On) or trailing (Off) edge of strobe.
MAC Binary Configure the printer to process Macintosh binary PostScript print
PS jobs.
.
4512-220, -230
Values
Deactivate (default)
Activate
Off (default)
On
Off (default)
On
Off
On (default)
Values
Off
On
Auto (default)
Standard
Fastbytes (default)
Off
On (default)
Off–The printer filters
PostScript print jobs using
Standard protocol.
On–The printer processes raw
binary PostScript print jobs from
computers using the Macintosh
operating system. This setting
often causes Windows print jobs
to fail.
Auto (default)–The printer
processes print jobs from
computers using either
Windows or Macintosh
operating systems.
Diagnostic aids
3-5