Lexmark E250DN - Govt Laser 30PPM Special Build Mono Taa Service Manual page 114

4512-220, -230
Fuser removal
1.
Remove the left side cover. See
2.
Remove the right side cover. See
3.
Remove the rear cover. See
4.
Loosen the top cover by removing the one rear screw above the reverse solenoid. Release the side
latches, and lift the rear of the top cover.
5.
Remove the paper exit guide assembly. The gears of the exit guide must clear the fuser bracket without
touching it. See
6.
Remove the two screws (A) and the one machine screw (B) that secures the ground cable.
7.
Disconnect the thermistor cable above the fuser.
8.
Remove the controller card cover.
9.
Disconnect the exit sensor cable from J11 on the controller card.
10.
Disconnect the fuser power cable above the fuser.
4-22
Lexmark™ E250d and E250dn
"Left side cover removal" on page
"Right side cover removal" on page
"Rear cover removal" on page
"Paper exit guide assembly removal" on page 4-37
4-4.
4-5.
4-6.
for more information.