RRP 41 Electrical Chassis (Card Cage) Assembly
Figure 7-47 Electrical Chassis Assembly
Removal
Caution
Before removing the Electrical Chassis Assembly, it is
recommended to store Engine NVRAM data on the Hard
Drive (see Store Engine NVRAM on page 6-150).
1.
Remove the Right Cover (RRP 1, on page 7-154).
2.
Remove the Top Cover (RRP 3, on page 7-156).
3.
Remove the Rear Cover (RRP 5, on page 7-158).
4.
Remove all three Shields (RRP 10, on page 7-164).
5.
Remove the Image Processor Board (RRP 39, on page 7-202).
6.
Disconnect the nine wiring harnesses along the edges of the engine
controller board. Seven of these harnesses are in front of the controller
board. The other two are on the left side.
Note
Two of the engine control connectors have connector
locks. There is one harness clip to release.
7-204
Phaser 7700 Color Laser Printer Service Manual