RRP 75 Set Clamp Clutch and Gear
Figure 11-17 Set Clamp Clutch and Gear
Removal
1.
Remove the Rear Cover (RRP 72, on page 11-330).
2.
Remove the set clamp actuator.
3.
Remove one screw from the set clamp actuator retainer and remove.
4.
Remove the clutch collar and clutch.
5.
Remove the gear.
Replacement
Note
When replacing, after installing the clutch collar you need
to depress the clutch solenoid and rotate the set clamp
shaft 1/4 revolution Counter-Clockwise, then install the
set clamp actuator. Rotate the clutch until the solenoid
snaps into position.
11-334
Phaser 7700 Color Laser Printer Service Manual