Smooth Fitness V2300 Owner's Manual page 20

"C T
ONSOLE
PROBLEM POSSIBLE CAUSE
E1 No Motor signal
The Computer cannot
E2 make contact with the
IC Chip
The Computer is
NOT receiving a
Pulse Signal
No Hand
Pulse Signal
or incorrect
The Computer is
Hand Pulse
receiving a faint or
Signal
intermittent Pulse
Signal
The Adaptor is not
The LCD plugged in (item
Screen does power supply from
Adaptor)
not display
anything
The Computer is
faulty
The Computer isn't
receiving a signal
from the Speed
The Speed
Sensor?
Display Show
"0"
The Sensor is faulty
The Computer is
faulty
S
ROUBLE HOOTING
SOLUTION
1. Motor Malfunction
2. Magnetic System
Malfunction or got stuck
3. Connection Wires are not
well-connected or broken
4. Console Malfunction
1. Disconnect the Adaptor or Batteries. Reconnect the Adaptor or Batteries to REBOOT
the system. Wait two minutes then verify that the system works correctly
2. If IC Chips is not well-assembled. Remove and reinsert the IC Chip
3. If the above solutions couldn't solve the problem, replace the IC chip with a New IC
Chip
Verify that the Hand Pulse Sensor Wire Plugs are connected FIRMLY and correctly
The Hand Pulse Sensors will NOT operate correctly if your skin is extremely dry.
Moisten your hands with a little water and try again.
Grasp the Hand Pulse Sensors firmly and avoid moving your hands while exercising.
The computer will need a few seconds to detect and display your correct pulse rate. If
this does not work, try relaxing your grip on the Hand Pulse Sensors
Clean the Hand Pulse Sensors to ensure a good contact between your body and the
Pulse Sensors
The problem still exists, replace the Hand Pulse Sensors.
Check that the Adaptor is correctly connected to an electrical outlet and plugged into
the socket on the machine correctly
Replace the Computer
Verify the gap between Speed Sensor and the Magnet is 5mm or less
Verify that all the Wire Plugs are connected FIRMLY, correctly and are not damaged
Verify that the Sensor Magnet is installed correctly
Replace the Speed Sensor
Replace the Computer
G "
UIDE
Replace Motor
Replace Magnetic System/Flywheel
Check whether the wires are well-connected or replace the
broke wires with the new wires
Replace Console
20