Table of Contents
Advertisement
"A
I
SSEMBLY
NSTRUCTIONS"
S
–
TEP 8
Short Extension Pulse Wire & Rail Decoration Assembly
a. Follow FIG.1 to plug the Short Extension Pulse Wire (183) into the connector located on the front bottom side of the
Seat Rail (91).
b. Attach the Left Rail Decoration Cover (41) and the Right Rail Decoration Cover (42) to the rear side of the Seat
Rail (91) and secure with one Self-Tapping Screw, Truss Head (M4x20mm)(131) and two Screws, Round Head
(M5xp0.8x15mm)(138).
S
–
TEP 9
Adjusting Handle Assembly
a. Attach the Adjusting Handle (55) to the Adjusting Handle Stand to the proper position.
b. Secure the Adjusting Handle (55) by rotating the Nut (M8)(168) in
against Adjusting Handle (55). NOTE: Please notice that the Nut (M8)(168) has been pre-assembled on the
Adjusting Handle
Stand.
**Make sure the above parts are tightened before moving on to the next page**
USE HARDWARE KIT
counterclockwise direction until completely tight
10
B
Hide quick links:
Advertisement
Table of Contents
