Step 4 - Leveler Assembly - Smooth Fitness V2300 Owner's Manual

"A I
SSEMBLY NSTRUCTIONS"
S –
TEP 3 Rear Stabilizer Assembly
a. Attach the Rear Stabilizer (8) to the Rear Support Frame Assembly (2).
"Helpful Hint: Only hand tighten the bolts and fasteners in each step. Wait until the step is completed
before fully tightening the bolts and fasteners"
b. Attach two Carriage Bolts (M8xp1.25x90mm)(164) that secure the Rear Stabilizer (8) to the Rear Support Frame
Assembly (2).
S –
TEP 4 Leveler Assembly
Thread the Leveler (38) tightly into the Rear Support Frame Assembly (2). **To properly adjust Leveler (38), please
review page 14 of the manual**.
S –
TEP 5 Rear Support Frame Assembly
a. Connect the Pulse Sensor Wire 3 (182) to the Pulse Sensor Wire 2 (181). Be careful not to pinch the wires.
NOTE: After connecting the wires, slightly and gently pull two sides of wires to test the that the
connectors are properly locket together.
NOTE: Four Nylock Nut (M8xp1.25)(171)
Support Frame Assembly (2).
b. Remove four Nylock Nut (M8xp1.25)(171)
c. Attach the Rear Support Frame Assembly (2) to the Main Frame (1) and reattach the four Nylock Nut
(M8xp1.25)(171). Be careful not to pinch the wires. Fully tighten nuts now.
d. Attach the Connection Cover (27) to the Main Frame (1) using a Screw, Round Head
(M5xp0.8x40mm) (139).
**Make sure the above parts are tightened before moving on to the next page**
will be pre-attached on the front of the Rear
from the front of the Rear
8
USE HARDWARE KIT
Support Frame Assembly (2)
A