Setting Up Two Wnhd3004 Units; Setting Up Two Wnhd3004 Units At Once; Adding An Additional Wnhd3004 To Your Network Later - NETGEAR WNHD3004 - High Performance Wireless-N HD Home Theatre Adapter User Manual

Setting Up Two WNHD3004 Units

You can set up multiple WNHD3004 units, for example if you purchase them in the same package.
Follow the instructions below.
Internet
Router/gateway
Figure 2-4

Setting Up Two WNHD3004 Units at Once

Follow these steps to set up two WNHD3004 devices.
1. Connect the Ethernet cable from a LAN port in the router or gateway to either LAN port on
one home theater adapter.
2. Place the other home theater adapter near the media player, game console, or switch and
connect it with an Ethernet cable.
3. To complete installation, connect power adapters to the Wireless-N Bridge(s). Allow a few
minutes for your devices to connect to the Internet.

Adding an Additional WNHD3004 to Your Network Later

Home theater adapters, if purchased as a kit, are pre-configured to securely connect to each other
automatically, according to the instructions above. To add another WNHD3004, simply use the
WPS (Wi-Fi Protected Setup) push button.
1. Make sure the WNHD3004 you are adding is set to Auto or Bridge mode but not set to AP
mode, and place it near the devices you will connect to it.
Setting Up Your Wireless Network
3DHD Home Theater Adapter WNHD3004 User Manual
AP Mode
WNHD3004
v1.0, November 2010
Bridge Mode
Gaming console
WNHD3004
Digital Media Adapter
2-5