Processor Power Module - Compaq AP500 Maintenance And Service Manual

Processor Power Module

The processor power module (voltage regulator module) is located on the system board.
To remove the processor power module:
1. Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2. Remove the following components:
Workstation feet
Side access panel
I/O bracket assembly
Press outward on both latches of the processor power module at the same time 1, then lift
3.
the module from the system board 2.
Figure 3-47. Removing the processor power module
To replace the processor power module, reverse the above procedure.
CAUTION: Static electricity can damage the electronic components of the
workstation. Before beginning these procedures, make sure you are properly
grounded. See "Electrostatic Discharge Information" in Chapter 2.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
2
1
Compaq Professional Workstation AP500 Maintenance and Service Guide
3-49