Removing The Card Guide - Compaq AP500 Maintenance And Service Manual

Removing the Card Guide

To remove the card guide:
1. Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2. Remove the following components:
Workstation feet
Side access panel
I/O bracket assembly
Full-length expansion boards, if installed
3. Using a blunt tool, press inward on the two center tabs on the card guide.
4. Gently pull the card guide out.
Figure 3-13. Removing the card guide
To replace the card guide, reverse the above procedure.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
Compaq Professional Workstation AP500 Maintenance and Service Guide
3-17