Removing A Dimm - Compaq AP500 Maintenance And Service Manual

Removing a DIMM

To remove a DIMM:
1. Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2. Remove the following components:
Workstation feet
Side access panel
AGP graphics controller, if necessary
Press outward on both latches of the DIMM at the same time 1. This releases the module
3.
and pushes it partially out of the socket.
Lift the module from the socket 2.
4.
Figure 3-45. Removing a DIMM
To replace a DIMM, reverse the above procedure.
CAUTION: When handling a DIMM, be careful not to touch any of the contacts.
Doing so may damage the DIMM.
CAUTION: Static electricity can damage the electronic components of the
workstation or optional boards. Before beginning these procedures, ensure that
you are properly grounded. See "Electrostatic Discharge Information" in Chapter 2.
1
2
1
Compaq Professional Workstation AP500 Maintenance and Service Guide
3-47