Epson Stylus COLOR 800 Service Manual page 141

13. Follow the menu by entering a dummy M/C No. in 3 digits and black/color head voltages
corresponding the installed printheads, then press "ENTER" key, and the menu below appears.
14. If the value input is incorrect, press "SPACE" and enter the correct value. If the input values are
correct, proceed to the menu shown below by pressing the "ENTER" key.
15. Enter "2" for "Select menu : ?" to select "S.F. paper print test" in the menu, then press "ENTER"
key, and the printer outputs the result of the head gap timing adjustment , along with the results of
other adjustments.
16. Look at the output to check if the lines are most closely aligned. If not, enter "9" for "Select menu :
?" to select "Return to the MENU", then press "ENTER" key to return to the sub menu.
17. Repeat the steps from 8 to 16 until the output is satisfactory, then enter "9" for "Select menu : ?" in
the menu indicated in Figure 4-31 and press "ENTER" key to return to the sub menu.
18. If there is no adjustment to be performed, enter "9" for "Select menu : ?" to select "Customer data
change/End" in the menu, then press "ENTER".
19. Enter "9" for "Select menu : ?" to exit the program.
Rev. A
Figure 4-31.
Setting Menu (3) for Print Inspection
Adjustment
4-21