Epson Stylus COLOR 800 Service Manual page 85

EPSON Stylus &2/25 800
4. Slide the ASF assembly to the left, then to the rear; and remove the ASF assembly from the
printer mechanism. Be sure to disconnect the ASF HP sensor cable from the sensor.
Connect the ASF HP cable to the connector at the left edge of the ASF before installing
the ASF assembly.
Several connectors are laid behind the ASF assembly. Make sure they are not cut under
the ASF assembly when installing the ASF.
Tightening torque for the screws (CBP, 4x10, F/Zn) = 10 ~ 12 kg-cm.
When engaging the gear (27.2 mm) and loading (LD) roller shaft, note the side they
face. Make sure they are correctly adjusted and securely locked. (See Figure 3-22.)
Figure 3-22. Engagement of Loading Roller Shaft and Gear (27.2 mm)
3-20
Rev. A