Waste Drain Ink Pad (Under The Asf Unit) Removal - Epson Stylus C 60 Service Manual

EPSON Stylus C60
4.2.9 Waste drain ink pad
1. Remove the Upper housing from the printer. (Refer to Section 4.2.1.)
2. Remove the ASF unit from the printer (Refer to Section 4.2.5)
Waste drain ink pad for tube stopper (1 sheet)
Figure 4-44. Waste drain ink pad setting position
3. Remove the Waste drain ink pad from the Lower housing.
When disassembling/assembling the Waste drain ink pad, be
careful not to hurt your hand with the protrusion of the Lower
housing. (Refer to Figure 4-44: Blue circle)
Disassembly and Assembly
removal
(under the ASF unit)
Waste drain ink pad (total 3 sheets)
When assembling the Waste drain ink pad to the Lower
housing,
Make sure to set the tip of the ink tube in the correct position
of the Lower housing. Otherwise, it will cause ink leakage.
Avoid contacting the gears in the pump unit.
Make sure to set the Waste drain ink pad in the correct
position.
When replacing the Main board with new one, perform the
following service items.
1) Waste drain ink counter reset (Protection counter A)
Disassembly
Waste ink pad
Ink tube
Figure 4-45. Ink tube setting position
Revision A
98