Waste Drain Ink Pad Unit Removal - Epson 680Pro - LQ B/W Dot-matrix Printer Service Manual

EPSON Stylus COLOR 680/777/777i

4.2.5 Waste drain ink pad unit removal

1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Remove one screw (C.B.P-TITE 3x8 F/Zn) on the front right side of the printer.
(viewed from front side)
Figure 4-12. Removing one screw securing the Waste ink pad unit
Disassembly and Assembly
3.
C.B.P-TITE 3x8 F/Zn screw
Figure 4-13. Removing one screws & cables at the back side of the printer
4.
Disassembly
Remove two screws (C.B.P- TITE 3x8 F/Zn) and take some cables off from the
cable hook in the Waste drain ink pad unit as shown in the following figure.
C.B.P-TITE 3x8 F/Zn
Remove the Waste drain ink pad unit from the printer
Revision B
C.B.P-TITE 3x8 F/Zn
73