Epson Stylus C 60 Service Manual page 66

EPSON Stylus C60
Occurrence
timing Detailed phenomenon
CR position
When a top of a paper at the correct
timing during the paper loading
sequence, the paper is ejected
immediately without setting the paper
setting position for printing.
Operation
The LD roller does not attempt to load a
-
paper during the paper loading sequence
although the PF motor and the Spur gear
60 rotate. (But, the drive of the PF motor
is not transmitted to the LD roller shaft.)
The LD roller is not set to the ASF home
position and a paper is always loaded
from ASF unit during the paper loading
sequence.
Troubleshooting
Table 3-9. Check point for the paper out error according to each phenomenon
Defective
unit/part name
1. Check if the Paper return plate operates correctly in the
ASF unit
1. Check if the Tension spring 0.143 comes off in the Clutch
2. Check if the Clutch comes off from the dowel of the LD
3. Check if the Clutch tooth is damaged.
Holder shaft unit
4. Check if the Clutch is damage.
1. Check if the Paper guide upper (only HP side) comes off
Paper guide upper/
left
1. Check if the Compression spring 1.764 comes off in the
Pump unit
1. Check if the tip of the Change lever is damaged.
Pump unit
Unit Level Troubleshooting
Check point
paper loading sequence.
mechanism.
roller shaft.
Tension spring 0.143
Clutch tooth
Dowel of the LD roller
from the Main frame.
Change lever.
Change lever
Comp. spring 1.764
Revision A
Remedy
1. Reassemble the Tension spring 29.1 between
the ASF frame and the Paper return plate.
Torsion spring 29.1
1. Reassemble the Torsion spring 0.143 in the
Clutch mechanism.
2. Reassemble the round portion of the Clutch
on the dowel of the LD roller shaft.
3. Replace the Holder shaft unit with new one.
4. Replace the Holder shaft unit with new one.
1. Reassemble the Paper guide upper to the
Main frame.
1. Replace the Printer mechanism with new one.
1. Replace the Printer mechanism with new one.
61