Epson Stylus C 60 Service Manual page 69

Hide thumbs Also See for Stylus C 60:
Table of Contents

Advertisement

EPSON Stylus C60
Table 3-12. Error condition before the initial ink charge/the I/C replacement CL and possible cause & Ink out error and possible cause
LED indication *
Error condition
STM3 message
Power : On
Error before the
Error : On
initial ink charge is
performed
Incorrectly installed
cartridge
Power : On
Error : On
Installed ink cartridge
Error before the ink
cannot be recognized
replacement CL is
Power : On
performed
Error : On
Black & Color ink
cartridge not installed
Power : On
Error : On
Ink out error
Black & Color ink out
* The above LED indication timing is at the CR home position. When the CR unit moves to the I/C replacement position with the I/C replacement sequence, this indication will change to blink
condition.
Table 3-13. Check point for the error before the initial ink charge according to each phenomenon
Occurrence
timing
Detailed phenomenon
CR position
The printer does not perform the initial
Power on
ink charge and the error is indicated with
Inside HP
LEDs and STM3.
Troubleshooting
Occurrence
CR position at the
timing
power on timing
Inside HP
Power on
Anywhere
Defective
unit/part name
1. Check if the ink cartridge can be used by install it to
Ink cartridge
1. Check if the incorrect data is stored into the 3C<H>
Main board
Unit Level Troubleshooting
Unit/Part name
Ink cartridge
The 1st ink cartridge is defective.
The incorrect data is stored into the specific address of the
Main board
EEPROM.
2nd or more ink cartridges is defective.
Ink cartridge
The ink cartridge is compatible or counterfeit one.
The ink cartridge is defective.
Ink cartridge
The ink cartridge is compatible or counterfeit one.
The ink amount in I/C is end condition.
Ink cartridge
The ink cartridge is defective.
Check point
other printer.
address of the EEPROM on the Main board.
Possible cause
Refer to Table 3-13
Remedy
1. Replace the ink cartridge with the brand-new
one.
1. Write the 9E<H> data into the 3C<H>
address of the EEPROM by using the Dump
exe. program in the Adjustment program.
Revision A
Check table
64

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents