Sensor Assy.,Load Adjustment - Epson DLQ-3000 Service Manual

Adjustment
The printer lets you check your print pattern selection for confirmation of the following
Step 11 :
steps 9 and 10 by printing one row of the pattern you selected.
Step 12: After the printer prints check patterns for confirmation, the following message appears
on the display:
If Bi-D is correct, press "Y' and the ENTER key, and
If your printed pattern is aligned vertically, press Y and Enter to complete the Bi-D
Step 13:
adjustment. Otherwise, press N to return to step 9 to specify another adjustment value.

4.5 SENSOR ASSY.,LOAD ADJUSTMENT

This section describes the SENSOR ASSY.,LOAD Adjustment procedure necessary to store in
paperless condition when the SENSOR ASSY.,LOAD is replaced.
The procedure is as follows:
Note: After performing the Defaults and Machine Information, perform the SENSOR ASSY.,
LOAD a@"ustment.
Step 1 : Set the SHEET GUIDE 4SSY.,FRONT which is in stacking condition to the printer.
Step 2 : Pushing 'TEAR OFF" and "SELECT TYPE" switches at the same time, turn on the
printer.
The printer is in the adjustment condition.
Step 3 : Confirm that the four LEDs turn on and the LCD display turns dark.
Step 4: Confirm the printer initialization, then turn off the printer.
When the printer is turned off, the paperless condition of the SENSOR ASSY.,LOAD is stored in the
SHEET
Figure 4-7. SENSOR ASSY.,LOAD Adjustment
4-8
Rev. A