Figure 3-10. Removing The Printer Mechanism - Epson DLQ-3000 Service Manual

Disassembly and Assemb/y
3.2.6.1 Removing the Printer Mechanism
Remove the HOUSING ASSY.,UPPER. (Refer to Section 3.2.5.)
Step 1 :
Step 2:
Remove the two screws CBS (M3 x 6) from both sides of the frame which fix the printer
Step 3:
mechanism to the left and right GRANDING PLATEs.
The screw orI the right side should be removed by inserting a Screwdriver from under the
Note:
Step Remove the screw CBS (M3 x 6) which secures the FG cable of the control panel harness
4:
at the right front of the mechanism. Then remove the FG cable from the printer
mechanism.
Remove all the connectors from the back right of the printer mechanism.
Step 5 :
Remove the four screws CBB(P)(M4
Step 6:
HOUSING ASSY.,LOWER. Then remove the printer mechanism.
2 The FFCS should be inserted so that the coated side faces outward.

Figure 3-10. Removing the Printer Mechanism

3-12
25) which fix the printer mechanism to the
x
Rev. A