Removing The Carriage Assy - Epson DLQ-3000 Service Manual

Attach the TIMING BELT,CR as 3-10 teeth of the TIMING BELT appear.
CARRIAGE ASSY.
Figure 3-23. Attaching the TIMING BELT,CR
Remove the two HEXAGON NUTS WITH OW(M4) securing the SHA~,CR,GUIDE,
Step
7:
UPPER to the FRAME ASSY.,LEFT and RIGHT. Remove the SPRING,154 and then
remove the SHAIT,CR,GUIDE, UPPER upward.
Remove the HEXAGON NUT WITH OW(M4) securing the LEVER,G,ADJUST to the
Step 8 :
PARALLEL,SHAFT. Then, remove the CARRIAGE ASSY. with the SHAFT,CR,
right.
Pull out the SHAFT,CR,GUIDE,LOWER.
Step 9:
\
Figure 3-24. Removing the CARRIAGE ASSY.
Rev. A
TIMING BELT,CR
Remove the SPACER,CR$HAFT and the LEVER,
Disassembly and Assemb/y
3-10 teeth
HEXAGON NUT WITH OW(M4)
3-19