Eclipse CD5030 Owner's Manual page 47

Registering using a cell phone
If a cell phone is currently connected, it must be
disconnected prior to registration of additional
cell phones.
In the Phone Setting selection
1
mode, select "Registration" by
pressing the [ ] or [ ] button.
Press the [ENTER] button.
2
ATTENTION
"NO ENTRY" will be displayed if available. If
not, a double beep will be heard if the phone
registration memory is not available or full.
Select "Allow Connect" by
3
pressing the [ ] or [ ] button.
Press the [ENTER] button.
4
The "Waiting" message appears on
the display.
Use the cell phone to select the
5
main unit name.
The name of this unit is ECLIPSE BT.
ATTENTION
• For details on how to operate the cell
phone, read its instruction manual.
• Be sure to perform the registration of the
cell phone only while the "Waiting" message
is on the display.
Use the cell phone to input the
6
passcode.
The default passcode is 1234.
ATTENTION
For details on how to operate the cell phone,
read its instruction manual.
The Bluetooth hands-free function
When the registration has been
7
completed, "COMPLETED" will be
displayed.
The cell phone has been registered.
( and appear on the display.)
If the registration has not been
successfully completed, the "FAILED"
message appears on the display.
Repeat the registration procedure.
ATTENTION
• To register another cell phone to the main
unit, press the [ /BAND] button twice after
Step 7. Perform the registration procedure
from the registered cell phone selection
mode in Step 1.
• You cannot register an already registered
phone number again.
• Both hands-free function and the audio
function may be connected at the same
time for some cell phones. In such a case,
register the hands-free function of the cell
phone first.
IX
47