Listening To Music Files In Usb Memory; Disconnecting Usb Memory - Eclipse CD5030 Owner's Manual

Operation
Listening to music files in USB
memory
Connect the USB memory to the
1
USB connector.
Hold down the [SOURCE/PWR]
2
button for less than 1 second until
the USB mode is shown.
For details, refer to "Switching Audio
Modes" on page 17.
3
Operate the USB music file player.
The procedure for playing music is the
same as that are used to play CDs.
For details, see "How to operate the
CD/MP3/WMA player" (page 27 - 29).
ATTENTION
If the USB mode is changed to another mode
and then returned to the USB mode, the player
will return to the previous file played.
CAUTION
1 2
• Do not disconnect the USB memory or turn
the ignition key to ACC OFF position while
accessing the USB memory. Doing so may
corrupt the data.
• Depending on the type connected, the USB
memory may not work in some cases.
• The USB memory does not support multi-
partition. Also, it does not support USB hub.
• It is highly recommended to back up your
data in case of accidental deletion.
• Install and use the USB device in a place
that provides safe operation of the vehicle.
• The music files under the copyright
protection cannot be played.
• When connecting a digital audio player to
the USB connector, additional USB
adaptors may be required.
34

Disconnecting USB memory

Disconnect the USB memory
1
parallel to the USB connector.
ATTENTION
Do not disconnect the USB memory during
playback.
CAUTION
1 2
Do not apply excessive force when removing
the USB memory. Doing so may damage the
USB connector and/or the USB memory.