Vauxhall Combo Owner's Manual page 31

26 Instruments
C
Main beam
The control indicator is illuminated when
main beam is on and during headlight
flash - see page 93.
!
Preheating for diesel engines 3,
diesel particle filter 3
Control indicator illuminates during
preheating.
Preheating system switches on only if
outside temperature is low.
Flashing (vehicles with diesel particle filter):
The diesel particle filter must be cleaned.
As soon as the road surface and traffic
situation permits, briefly increase speed
over 25 mph (40 km/h). The control
indicator goes out as soon as cleaning is
complete.
T
Easytronic Winter programme 3
Control indicator is illuminated when
Winter programme is enabled.
Further information – see page 113.
r
Fog tail light
The control indicator is illuminated when
the fog tail light is on - see page 95.
Picture no: 18122s.tif
p
Alternator
The control indicator illuminates when the
ignition is switched on and goes out shortly
after the engine starts.
If it illuminates when the engine is running:
Stop the vehicle and switch off the engine.
The battery is not being charged. Engine
cooling may be interrupted. Check drive
belt condition and tensioning before
contacting a workshop. We recommend
your Vauxhall Authorised Repairer.
Picture no:
R
Brake system,
clutch system 3
The control indicator illuminates when the
ignition is switched on if the handbrake is
applied or if the brake or clutch fluid level 3
is too low. Further information -
see pages 130, 186.
9
Warning
If it illuminates when the handbrake is not
applied: stop the vehicle; interrupt your
journey immediately. Consult a
workshop. We recommend your Vauxhall
Authorised Repairer.
On vehicles with Easytronic 3, control
indicator R flashes for a few seconds after
the ignition is switched off if the handbrake
has not been applied.