Vauxhall Combo Owner's Manual page 161

156 Self-help
Picture no: 11647s.tif
7. Screw in wheel bolts and tighten
slightly, inserting the wheel bolt
wrench 3 as far as possible.
On some model variants, the wheel trim
must be positioned before the wheel
bolts are tightened.
8. Lower vehicle.
9. Tighten wheel bolts crosswise, putting
on wheel bolt wrench 3 as far as
possible.
Alloy wheels 3: put hub cap on and
engage, inserting pin on rear of hub
cap into relevant hole in wheel.
Alloy wheels with anti-theft lock 3:
put hub cap on. Insert and tighten
anti-theft lock 3.
10. Before refitting the wheel trim, clean the
wheel around the retaining clips. Valve
symbol 3 on back of wheel trim must
point towards valve on wheel.
Align and engage hub cap or wheel
trim 3 and wheel bolt caps 3.
11. Stow the replaced wheel, tools and
warning triangle - see pages 148, 151.
12. Check the tyre pressure of the newly
fitted wheel. Adjust as necessary.
13. Have the tightening torque of the wheel
bolts on the new wheel checked on the
vehicle using a torque wrench as soon
as possible and, if necessary, corrected.
Tightening torque – see page 205.
14. Replace the faulty tyre on the wheel
that was removed.
15. Replace the temporary spare wheel 3
with a full specification wheel without
delay.