Directed Electronics AutoCommand 28623TN Owner's Installation Manual page 57

➤
The user steps on the brake as they begin to drive the
vehicle
Safety shut down inputs:
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down
the engine if the system receives any of the following shutdowns
➤
The brake pedal is pressed.
➤
The hood is opened.
➤
The programmed run time has elapsed.
➤
Low battery voltage
➤
High or low tachometer signal
Quick Stop Mode
The Quick Stop feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful
for occasions when you wish to exit the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To activate Quick Stop:
➤
With the ignition On and the engine running, do one of
the following:
■ Press and release on the transmitter
twice.
■ Press and release the Momentary Switch 4 times
quickly
■ Pulse the activation input wire twice
54
button
© 2006 Directed Electronics